[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
Measure the outside diameter of the larger opening and buy a length of
carburetor preheat hose, preferably the fiberglass impregnated stuff -- it lasts
much longer than the plain paper stuff. Clamp it using worm drive hose clamps
(stainless steel ones).
I don't know if they make a preheat hose that's as small as the cool air pipe
one. Mine were removed when I went to carbs so I never needed to replace it.
Toby Erkson, air_cooled_nut@pobox.com
'72 VW Squareback 1.6L bored and stroked to 2.0L
'75 Porsche 914 1.8L
Portland, Oregon, http://www.geocities.com/MotorCity/8501/
______________________________ Reply Separator _________________________________
Subject: need heater parts
Author: type-3-errors@umich.edu at SMTPGATE
Date: 12/8/97 8:01 PM
Help!
I need two heater hoses for a '68 fastback:
One fat flex hose that connects the heat exchanger to the box that controls
the mixture of hot and cool air.
One thinner flex hose that connects the cool air pipe to the same box.
I'm c-c-c-old!
Dean Curtis
thejab@prodigy.net
'68 fastback