[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]

Re: [T3] Gas gauge question


<x-flowed>The sender is the same for 6 volt or 12 volt. There may be a problem with your sender, but it's not the voltage.

Scott
62 343

On May 2, 2006, at 6:22 PM, Donald Croxton wrote:

some body told me  it will work with drop voltsage ?
----- Original Message ----- From: "Rusty Rockers" <cndt3@shaw.ca>
To: <type3@vwtype3.org>
Sent: Saturday, April 29, 2006 9:28 PM
Subject: Re: [T3] Gas gauge question


I'm using a 12V sender in my 63 Notch (still 6V) without any problem. Turn
your key on then disconnect the wire at the sender then ground it. If your
gauge now reads full you've got a problem with the sender. These can
sometimes be fixed but I didn't have much luck with this. I had to try a
few used units before I got one to work.


Andre

the gas gauge didnt work becuase of sending units is 12 volts and i think
gas guage is 6 volts.


question i have to get 67 gas gague with 12 vts will work with 12 vts
sending units ?

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~



</x-flowed>

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]