Re: [T3] Rusty Seats!

["Mike" <fisherfarms@uwol.net>]

<x-flowed>I didn't realize the bug is narrower!  I wonder if I could grind/cut the 
rails out with the seats attached?  I have grinder and reciprocating saw but 
no torch.  It would be easier to cut in front of and behind the seats.  That 
still leaves the" section of pan" rusted to the seats but should be easier 
upside down on the garage floor?  I still trying to get the seatbacks to 
tilt forward? Mike
----- Original Message ----- 
From: "Jason Weigel" <notchboy@satx.rr.com>
To: <type3@vwtype3.org>
Sent: Tuesday, January 24, 2006 9:37 AM
Subject: Re: [T3] Rusty Seats!


> You can make anything work with fabrication. But a bug pan is different in 
> several aspects. The outer holes will not line up and its to narrow to 
> beginwith. If you were able to graft the pan in with the seat rails then 
> you would have to use bug seats and then they would also sit lower than a 
> stock T3 seat. You can find good pan halves for a T3. But most people are 
> not willing to shell out the $ for the actual prt and shipping.
>
> jason
>
>
>
> > I can use my floor pans as I havn't seen replacements?  Will a Bug 
> > footwell/seatrails work in T3?  Any advice/consolation ?  Mike 
> > Fisher----- 
>
>
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
>
>
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.375 / Virus Database: 267.14.21/235 - Release Date: 1/19/2006


</x-flowed>