Re: [T3] Push rod tube oil seal repl

[Chris Wright <Christopher.Wright@Sun.COM>]

<x-flowed>Try the compressable bugpack ones as per my mail.  15 minutes and you're 
leak free.  No need to remove the engine, or the head.
Chris
type3weezer@comcast.net wrote:

> There's now way you could pull the pushrod tube through the head like it says. The whole rocker arm assembly must come out and the cylinder head removed (the studs aren't long enough to leave the nuts on and still have enough room to remove the tube.) I would also suggest removing the engine to do this. If your going to lay under the car there is a good chance of bending a new tube when you put the heads back on. Three hands work best on this job and the time you save working on the bench will make up for the time it takes to pull and install the motor. (1/2 hour if I'm in a good mood ;-) Remmber if you do it right you only have to do it once. 
> --
> John
> 65 square (weezer)
> 04 jetta
> Just Cruisin By
>
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
>
>  

</x-flowed>