[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]

Re: Governor o-ring (was:Re: [T3] Passed test - good and bad news)


On Mon, 2005-05-30 at 07:25, Daniel Baum wrote:
> > The pinion is extremely loose - I don't believe that my meddling was 
> > responsible; it must have been like this for years. I'll try Russ's 
> > suggestion of using a center punch to make the hole narrower. My local 
> > tool shop did not have one in stock this morning - they should have it 
> > tomorrow and I'll let you know how I get on.
> 
> Not a success. There is now a distinct dimple in each of the flats around 
> the end of the governor, and the pinion is still completely loose - it just 
> drops in and out.
> 
> The only thing I can think of is if I can somehow make the pinion wider, 
> rather than the governor narrower. What if I were to put a blob of solder or 
> epoxy putty on each side of it and then knock it in? or wrap it with 
> something?
> 
Once it is in place, it can't fall out. I would try a spot of epoxy to
hold it. If it comes loose after it is in there, it will not hurt
anything. 
Just remember how it is if you ever have to pull it back out, and remove
it gently.

-- 
Russ Wolfe
'71 FB AT
'66 FB MT
'64 T34 (not running)
'65 T1 (not running)
'05 KIA Sorento SUV
russw@classicvw.org
http://www.classicvw.org

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]