[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
In a message dated 3/21/05 9:10:02 PM Eastern Standard Time,
proformance2@cox.net writes:
<< I need to replace the head on my back up motor. The replacement is a 211
head and the others are 311. Will there be any problems by doing this?
>>
I don't think so. You're not using FI, so you don't have to worry about the
sensor location. As long as it matches the others, you should be fine. I think
the 211, and 311 are just different casting numbers that VW used to designate
when the tooling was first used.
Bob 65 Notch S w/ Sunroof
71 Square, now a 2 seat Roadster, pics can be seen at;
http://volksrods.com/forums/index.php?showtopic=2977
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~