[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[New Search]
Re: [T3] oil press. gauge sender
At 07:33 AM 12/5/2005, Jim Adney wrote:
The best place to connect it is in
the original location. You can use a Tee and
install both the OE switch and the VDO sender, or you can buy the special
VDO
dual switch/sender which does both functions separately but in one
package.
Does the tee method allow enough clearance for the stock air cleaner?
It's already a close call with just my stock sender... I have to bend the
connecting tip down at a 90 deg. angle so the wire doesn't contact the
underside of the cleaner, which leaves about 1/4 in clearance at
most.
There is usually not
enough room under the air cleaner for all of this, so
you'll usually need to use an elbow or find one of the OG right-angle
banjo
fittings that VW installed on the dual carb
engines.
A 90 deg. elbow to a tee sounds like it would do the trick. Time to take
some measurements.
Thanks!
Dave Y.
68 Sqbk
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[New Search]