[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 5 Oct 2004 at 7:42, Ian Ruinaard wrote: > Make up a short tube that fits over the clutch cable tube & is just long > enough so that the end of the flexible cable lands on the top of the tube. > Braze or weld a big washer on end of the tube. Slip this over the end of the > clutch cable tube before you fit the flexible cable. What it then should do > is transfer the load directly from the flexible cable into the bulkhead. That would work just fine. In fact, you should not even have to braze/weld the tube to the washer. You could even just use a stack of washers. This would make it easy to adjust the length. -- Jim Adney jadney@vwtype3.org Madison, WI 53711-3054 USA ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~