[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]

Re: [T3] Braided Wire in Distributor


On 6 Nov 2004 at 21:20, The Canadian wrote:

> I have a distributor whose braided wire is almost disconnected at one of the
> ends.  How should I reattach it?

Take the breaker plate out of the dist, and take it completely apart. Remove 
the points and clean all the oil and grease off. Snip off the remaining braid. 
Use a bit of desoldering braid to replace this piece; make sure that it's long 
enough that it can flex freely as the vacuum advance moves. Solder the ends to 
the old attachment points on the 2 breaker plates.

-- 
*******************************
Jim Adney, jadney@vwtype3.org
Madison, Wisconsin, USA
*******************************

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]