[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
russ wolfe email me dchw65@comcast.net about the plate over ----- Original Message ----- From: "Russ Wolfe" <russw@classicvw.org> To: "Type 3 List" <type3@vwtype3.org> Sent: Sunday, November 07, 2004 11:31 AM Subject: Re: [T3] Wont idle.....still > On Sun, 2004-11-07 at 13:22, Jason Weigel wrote: > > Ok my turn with the hair pulling problem. As some of you may remember I > > recently took my early single port, side draft motor down to the long block > > and cleaned it all up real well. > > > > Well Ive since tried to get it started with it firing but not ideling. Ive > > taken the carb off and cleaned out the plugged idle passage ways. Put the > > carb back on with the same problem. So I put a known working carb on. Same > > problem. I rebuilt the fuel pump. Same problem. > > > > Problem is it starts and remains running if I feather the gas. As soon as I > > let off it dies. Re start, it shoots to life then dies if I dont feather it. > > It dosnt accelerate well eithor. I have to feather it to get it up to high > > RPM. > > > > Is my timming off, would it cause this? The trouble with this early motor is > > it has two marks on the fan. What are they? 0,7.5 or 10?? It also has NO > > mark 180 deg out for 2 and 4 setting. So I could be setting it wrong. > > > > Any input? > > > This sounds more like a vacuum leak. or a problem with the idle circuit > in the carb. Since it does it with 2 different carbs, I would look for a > vacuum leak. Especially since you had the intake manifold off. > > -- > Russ Wolfe > '71 FB AT > '66 FB MT > '64 T34 (not running) > '65 T1 (not running) > russw@classicvw.org > http://www.classicvw.org > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > >