[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]

Re: [T3] T3 Distributor!


----- Original Message ----- 
From: "Jim Adney" <jadney@vwtype3.org>

>
> What's the part #? It's hard to see from here, but I can tell you that
it's the
> wrong vac adv can; it may work fine, however. Is there a 3-digit number on
the
> actuating arm?


It is listed as a replacement for 68-69 FI T3.

I'm looking at it closer now.The wire braid is missing and has been
replaced with a short length of insulated wire about the same gauge
as the points wire.Nice neat ring terminals on each end.Lube at
points rubbing block,the little plate and ball,and present under the
advance plate.NO radial or axial slop.Trigger points nice and stiff.
Cam lobe sharp and well defined.Bottom tangs look new.

http://www.oldvolkshome.com/ignition.htm#C6869FM


D.V. Nelson

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]