RE: [T3] generator pulley - mm wrench size?

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]

RE: [T3] generator pulley - mm wrench size?

To: "'type3@vwtype3.org'" <type3@vwtype3.org>
Subject: RE: [T3] generator pulley - mm wrench size?
From: "Vlach, Joe -CKHS" <JoeV@cksd.wednet.edu>
Date: Thu, 29 May 2003 06:43:45 -0700
List-help: <mailto:type3-request@vwtype3.org?subject=help>
List-post: <mailto:type3@vwtype3.org>
List-subscribe: <mailto:type3-request@vwtype3.org?subject=subscribe>
List-unsubscribe: <mailto:type3-request@vwtype3.org?subject=unsubscribe>
Old-return-path: <JoeV@cksd.wednet.edu>
Reply-to: type3@vwtype3.org
Resent-date: Thu, 29 May 2003 06:46:17 -0700 (PDT)
Resent-from: type3@vwtype3.org
Resent-message-id: <cEiyN.A.GkG.p8g1-@cedant5>
Resent-sender: type3-request@vwtype3.org

Want a good laugh...I had trouble getting the "hat" nut off when removing
the generator. I took a trowel, placed the "hat" nut on it and traced a
pattern, cut it out and it makes a cheap but good off set thin wrench to fit
in that tight spot.

-------------------------------------------------------------------
List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]