[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]

Re: [T3] Cylinder Head Type


On Fri, 2003-01-03 at 22:07, Jim Adney wrote:
> On 3 Jan 2003 at 15:44, Gary Gamboa wrote:
> 
> > I have been pricing cylinder heads and have seen them referenced as single
> > and dual port.
> > Which type was stock on a '71 square FI AT?
> 
> They are dual port. The left side is a special FI DP head with a tapped hole 
> for the cyl head temp sensor. I think FI beetles use this same head on the 
> right side.  
> 
There are 2 different dual port heads for the FI T-3, with the
temperature sensor mount.. There is a step in the head where the
cylinder mates on the later ones that lowers the compression ratio.
I just tore an engine down that had one of each on it.

-- 
Russ Wolfe
'66 FB MT (It drove)
'71 FB AT 
'65 Bug (not running)
russw@classicvw.org
http://www.classicvw.org



------------------------------------------------
To unsubscribe, E-mail to: <type3-off@vwtype3.org>
For more help, see http://vwtype3.org/list/

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]