[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On Sun, 2003-08-17 at 12:40, Jim Adney wrote: > On 17 Aug 2003 at 11:02, Russ wolfe wrote: > > > I use a 1/2" copper solder fitting on mine. I connect the female end to > > the fill neck with a very short piece of hose, and a couple clamps. I > > then run a piece of 5/8" (16mm) hose from that to the "Tee" inside the > > trunk. > > Do you do anything special to seal around the hose where it passes thru the > fender wall? Or did you find a hose that is a tight fit? > The OD if the hose I use is pretty close to ID if the hole in the bulkhead without the grommet. I would just use a little caulk around it if I had any inner fender well to worry about. -- Russ Wolfe '66 FB MT '71 FB AT '65 Bug (not running) russw@classicvw.org http://www.classicvw.org ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org