[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]

Re: [T3] Squareback headliner install


Jacob, I haven't looked at the info that you retrieved. I have done a sunroof 
model headliner before (in my Notch), using the TMI/J Bugs kit. The kit they 
send will not have the hole already cut into it, as you must do that your 
self. They will however include a piece for the bottom of the sunroof insert to 
finish the job off. At least this is how mine was when I got it and did it. One 
thing to remember before you start, and that is you have to remove all of the 
sunroof parts because the inner panel only can be removed with the whole unit, 
and you need to remove it to recover it. They also sent me the interior 
video, which was some help, for ideas only, as it concentrated on a non sunroof 
bug. My advice is when you go to cut the hole have the rest or most of the rest 
done, and cut the hole smaller than you need and trim it as you go. Its easier 
to cut a little than it is to try and fix a mistake. Also pay attention to 
where the bows go, as in the sunroof section of the roof there aren't any, but 
the headliner will have provisions for them (at least mine did). I hope this 
helps.

Bob 65 Notch S w/ Sunroof
       69 Square AT-the baby suburban

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]