[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 17 Apr 2003 at 19:14, Aaron Clow wrote: > I went to check cyl #3's valves and ran into a problem a couple seemed > to have had on the list, although the explanation was usually that they > should double-check the pully is in the right spot... I couldn't get > the feeler gauge in no matter how far I moved the adjusting screw. > Initially I put the pulley at 0 degrees and the distributor rotor was > pointing toward #1 cylinder. I rotated it 360 degrees to check cylinder > #3's valves (rotor was pointing at cyl #4) and I couldn't get the > feeler gauge in. What could be wrong? I flipped it around 360 degrees > again and was then able to get the gauge in. After the second 360 were you then able to do #3? If so, you were just looking at the wrong valves at the wrong time. Another 360 would have put you at the right place to do #1. -- ******************************* Jim Adney, jadney@vwtype3.org Madison, Wisconsin, USA ******************************* ------------------------------------------------------------------- List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org