[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]

Re: [T3] lower controling arm


<x-charset iso-8859-1>> the oversize stud is 111 405 175 A
>
> the pin is N 013 305 1
>
> Now I wonder which manual described this...?
>

The procedure is in the factory Type 3 workshop manual almost exactly as Jim
has described - drive out the dowel pin, drill out the remains of the stud
(3mm pilot then 10.75mm).  Drill hole 12.3mm and ream with 12.5 P8 12.455 -
12.482 (0.49035" - 0.4912") reamer.  If the reamer isn't available, grind
down the replacement stud to give an interference fit of 0.01 - 0.5mm
(0.0004" - 0.020").  Stud sticks out 45mm - 45.5mm.
Drill a 4mm hole in the stud for the dowel pin.  Drive in the pin.

After all those precision reaming instructions, it's OK to have the hole
1/2mm smaller!

Dave.
UK VW Type 3 & 4 Club
http://www.hallvw.clara.co.uk/
------

-------------------------------------------------------------------
Search old messages on the Web!  Visit http://www.vwtype3.org/list/

</x-charset>

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]