[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]

Re: [T3] Valve issues...


On 5 Mar 2002, at 14:40, PunkDork55@aol.com wrote:

>     On my engine, stock 67, dual carbs....  the engine is new, and not in the 
> car.... The dist. rotor points to the notch in the dist body, and the valve 
> gap is at .006", but the notch in the crankshaft pulley doesnt line up with 
> the little projection on the fan shroud.  its like a good 40degrees off... it 
> IS supposed to line up, right?  and the pulley can only go on one way, right? 
>  so then, this means that my longblock was assembled wrong? 

The pulley is most likely right. The dist drive is most likely wrong. You can 
make it work this way, but it will be a constant source of confusion. It's worth 
getting it corrected.


-
*******************************
Jim Adney, jadney@vwtype3.org
Madison, Wisconsin, USA
*******************************

-------------------------------------------------------------------
Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]