[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 1 Mar 2002, at 12:05, jadabrez wrote: > i am attempting to do my fist valve check. the manual > i have handy says "remove distributor cap and turn > engine until rotor points to notch in distributor rim > and crankshaft pulley timing mark is aligned with the > crankcase split or pointer." my problem is that the > mark on the pulley is ligned up but the rotor is not > pointing at the notch in the distributor rim. it is > about 10-15 degrees to the left (towards drivers > side). do i need to loosen the distributor and rotate > the body until the rotor is lined up or??? thanks > alot. No need to move the dist that little bit. Just line up on the pulley mark, making sure you understand what things you are lining up. Then adjust the #1 valves. After that you'll move the crank 180 deg at a time (while the dist moves 90 deg) and move on to #4, #3, and #2. - Jim Adney jadney@vwtype3.org Madison, WI 53711-3054 USA ------------------------------------------------------------------- Unsubscribe? mailto:type3-request@vwtype3.org, Subject: unsubscribe