[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 4 Apr 2002, at 20:10, Eduardo Godoy wrote: > Well, on my seats, the cam has stripped, the shaft > turns pointlessly, and my seat can't be adjusted > properly. So I bought a set from the junkyard, but of > course, the replacement seats have some problems of > their own (the rails are completely bent up). > I would like to remove the shaft/cam from the > replacement seats but I haven't been able to figure > out how to remove the shaft from the old seats. I was > able to push out the pressed pin on either side, but > can't get the knob off, any suggestions? The cams and the knob are all held on the shaft the same way, by a roll pin. In general it is not necessary to remove the shaft to fix things: Just press in a new pin. You may be able to buy something appropriate at the hardware store, or salvage enough from your junkyard seat to reuse. - Jim Adney jadney@vwtype3.org Madison, WI 53711-3054 USA ------------------------------------------------------------------- Unsubscribe? mailto:type3-request@vwtype3.org, Subject: unsubscribe