[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
anyone know of a good web site that would have some good instructions on synching and adjusting my carbs? just did a rebuild and they, obviously, hardly run. i'm going to get a flow synchrometer (is that what they're called?) tomorrow. all i need after that is a tach, right? i have a VDO tach i put in myself and that should be good enough, right? also, while i was rebuilding the carbs and i put the new volume control screw in, i noticed that on one side, the point stuck out into the throat about 1/16 to 1/8 of an inch when screwed all the way down. the other site went to about flush with the edge of the throat. so, should i be worried about the volume control screw sticking out at all? just to double check, that's how i start out, right, i just screw it all the way down until it stops and back it off 1 and 1/2 turns and then proceed with whatever adjustments? thanks, Dan Hoopes '67 Square, "Stanley" Provo, UT 9797 _________________________________________________________ Do You Yahoo!? Get your free @yahoo.com address at http://mail.yahoo.com ------------------------------------------------------------------- Search old messages on the Web! Visit http://www.vwtype3.org/list/