[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]

FW: [T3] seat removal




> To remove the seats you must push a clip downward.
> oN THE 1969 TYPE 3's
> 
> This clip is located next to the bottom of the seat next
> to the tunnel (car hump). You can see it by looking from 
> above the seat cushion into the area where the seat slides 
> on the rail, is kind of the front part of the rail next to the
> hump.
> You must push down on the clip and pull /push
> the seat slightly foreward FROM THE BOTTOM, this way
> the seat wont get stuck, then the clip will disapear under the
> slide. If this becomes very difficult you may have debris and 
> some little garbage preventing the clip from being pressed 
> all the way down. Clean it up an add some drops of oil to the 
> clip and slide. Use a screw driver to press down clip while pushing
> the seat foreward FROM THE BOTTOM. It is best if two people 
> do this, one presses
> the clip while another slides seat foreward. Once the clip is under
>  the rail, one person is only needed to slide the seat all the way 
> foreward until it is off the rail and ready to be pulled out of car.
> If you have any more questions please ask.
> 
> LEON MARTINEZ
> 
> 1969 SQUREBACK EFI/AUTO
> SAN DIEGO AND TIJUANA

-------------------------------------------------------------------
Unsubscribe? mailto:type3-request@vwtype3.org, Subject: unsubscribe


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]