[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]

Re: [T3]


The firing order is 1-4-3-2 starting at the mark in the edge of the
distributor housing. This it the small chisel mark, and not the large notch
that locates the distributor cap. This should be closest to the generator,
on the side of the cap next to the fan housing.

Russ Wolfe
russw@classicvw.org
http://www.classicvw.org/
----- Original Message -----
From: "Heather Woltz" <dopetoka@yahoo.com>
To: <type3@vwtype3.org>
Sent: Sunday, February 04, 2001 6:55 PM
Subject: [T3]


> Dear list,
>       I have just gotten new spark plug wires and i
> happened to exchange the wires correctly the first
> time, one at a time.   But i noticed one that had a
> rip in the insulation, black rubber outside layer.  SO
> i returned them.
>
> the problem is when i removed the wires again i just
> took them off, without taking note of the length of
> each wires.  I was wondering if someone could explain
> which wire goes to which cylinder(4,3,2,1).
>
> If there is a diagram with the dist. cap attached to
> the distributer, and which connection is to what
> cylinder, and possibly the lengths.  I suppose i could
> just experiment ,and eventually figure it out, but i
> was wondering if anyone knows this info.  Thanks
> again.
>
> Heather
>
> __________________________________________________
> Get personalized email addresses from Yahoo! Mail - only $35
> a year!  http://personal.mail.yahoo.com/
>
> -------------------------------------------------------------------
> List info at http://www.vwtype3.org/list or mailto:help@vwtype3.org
>
>


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]