[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]

Re: [T3] engine is ready


On 31 Jul 2001, at 22:55, Barry Viss wrote:

> I only have one where the right side,
> lower and upper tin pieces are screwed together, on the front (is
> front).  There are two holes here while the left only has one.  I
> guess it's no big deal.

I don't remember where all the screws go, but any decent hardware 
store will have an M6 x 1 bolt that will fit there, and 1/4" washers 
work fine. Bolts with hex heads also work nicely so that you can 
get good torque on them with a socket wrench. It's much better to 
get everything connected right now so that everything stays tight 
and secure. Otherwise you will be fixing this later when it's much 
more diffucult.

> Wish me luck everyone.

Hey, if you've been careful all the way thru up to this point, luck 
has little to do with it!  ;-)

Good luck anyway

-
Jim Adney
jadney@vwtype3.org
Madison, WI 53711-3054
USA

-------------------------------------------------------------------
Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]