[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]

Re: [T3] Lowering and raising the suspension

On 22 Jul 99, at 8:11, Steven Ayres wrote:

> => I wasn't able to do this because of the suporting arm to the Hub ass'y.
> It sounds like you may have missed a step. What specifically is in the
> way?

Sounds like he still needs to remove the diagonal arm pivot bolt.

> => are you sure the spring plate can move on the torsion bar?
> Yes, the cover is what holds everything together in the rear. Over time
> the grease turns to soapy crud and things get sticky, you may even have
> rust holding the plate to the bar; this is a pry-bar job under the best of
> circumstances. Go slowly and carefully.
> => do I have to open the covers in the body to get the torsion bar moved
> => enough? 
> Usually not. The body holes are there for actual removal of the bars. (If
> you eventually need to do this you can drop the subframe instead.)

I had to remove the covers on a swing axle. Are things enough 
different on the IRS that you don't?

> => What about the limiter above the torsion arm it is also connected to =>
> a torsion bar, what part does it play must it also be adjusted?
> The upper swing arms are connected to the anti-sway bar, not a torsion
> bar. No adjustment necessary. 

If you lower significantly won't you need to remove the whole Z-bar 
assembly. I think it will just engage all the time otherwise.

> => I'm also having trouble returning the torsion arm to its place there =>
> is some sort of ring inside it has to fit into.

I found this to be quite a job since you have to force the splines 
axially while they are under quite a bit of torsional force. They 
should be welYd at this point.

Jim Adney, jadney@vwtype3.org
Madison, Wisconsin, USA

Search old messages on the Web!  Visit http://www.vwtype3.org/list/

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]