[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
There is a socket-head screw with a locking nut on each. You tighten the screw to 22 ft lb, then the locking nut to 29 ft lb. The other end of each torsion bar is held by a bolt and a shaped plate. Dave. UK VW Type 3&4 Club www.hallvw.clara.net/ -----Original Message----- From: Thorkhild <Thorkhild@accessone.com> To: type3@vwtype3.org <type3@vwtype3.org> Date: 25 August 1998 22:40 Subject: [T3] front end problem HELP!!! >I just started to lower my front end on my '68 Fastback tat has a front end >from a 72. >The lower arm pulled out very easily on the right side and the left was >fairly easy with a few hits with a hammer. I put the arms where i wanted >and put it all back together. BUT now i can still pull out my lower arms >from the beam! What holds the arms in? or what broke? > > >Thorkhild >'68 fastback >'69 Squareback > >------------------------------------------------------------------- >Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe >