[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
>From: Phil w Burton <pburton@wilmington.net> >I am looing for a drive plate for a type 3 automatic so that I might >convert a 74 vw automatic bus for use with an upright engine. Forgive me if this is obvious, but the AT needs a non-standard gland nut that doesn't have the MT input shaft needle bearing; the torque convertor has a pilot that sticks in that space instead. If this bearing is there, it MIGHT be possible to bolt the drive plate up to the torque converter, but it would be under a lot of unusual stress. Jim --------------------------------------------------------------------- Melissa Kepner Jim Adney jadney@vwtype3.org jadney@vwtype3.org Laura Kepner-Adney Madison, Wisconsin ---------------------------------------------------------------------